Filter
Top Products
9
1. Select the mode
● When you wish to access a function in the D16’s
LCD screen, you must first press the appropriate
key to select the Mode that contains that function.
For details on the functions of each mode, refer to “Ref-
erence” (→p.45).
2. Select the tab page
Each mode contains a variety of parameters, which are
organized into pages. These pages are divided by tabs.
1 Make sure that the desired mode has been
selected.
The following figure shows the TEMPO/
RHYTHM page that appears when the [TEMPO/
RHYTHM] key is pressed.
2 Select the desired tab page. There are two ways to
do so.
• Press one of the tabs located at the bottom of the
page.
• Each time you press the currently selected mode
key, you will cycle through the available tab
pages.
Some pages have only one tab.
3. Select the parameter and make
settings
Selecting the parameter
Use one of the following methods to select the parame-
ter that you wish to edit.
● Directly press the parameter in the LCD screen.
● Press the up/down/left/right area of the [CUR-
SOR] key to move to the parameter.
● In a list display screen, move by rotating the
[VALUE] dial.
Setting the parameter value
The method of setting the parameter value will depend
on the type of parameter.
● Select the parameter to highlight it, and rotate the
[VALUE] dial to set the value.
This is the usual method, and applies to parame-
ters with an underline “_,” iconic parameters such
as EQ, and when using Locate to change the time.
There are also the following methods.
● Popup buttons, dialog boxes
Use a popup button to access a dialog box, and
specify the value of a parameter. (→p.8)
A dialog box can be accessed from a popup button
in the following ways.
• Directly press the button that you wish to select.
• Use the [CURSOR] key to select the parameter,
and press the [ENTER] key.
● Toggle buttons
These buttons switch a function or setting on/off
(→p.8). They can be switched in the following
ways.
• Press the button directly.
• Use the [CURSOR] key to select the parameter,
and press the [ENTER] key.
● Radio buttons
These buttons select one of multiple choices. They
can be selected in the following ways.
• Press the desired button directly.
• Use the [CURSOR] key to move the cursor to
the desired selection, and press the [ENTER]
key.
● Selecting a song or mark etc. from a list
The following methods can be used to select a sin-
gle item from a list.
• Directly press the desired item (name).
• Rotate the [VALUE] dial to select the desired
item.
● Selecting a song for a program play list
A special method is used only when creating a pro-
gram play list in the [SONG] “PrgPlay” tab page.
Select a song from the list, and perform the desired
operation for it.
1 Press a play list number.
2 Rotate the [VALUE] dial to select the desired
song.
Basic operations in the LCD
screen
Introduction
Ob
j
ects in the LCD screen and