Filter
Top Products
Bass (First Timbre A06) Piano + Strings (2
nd
and 3
rd
Timbre, A01 and A05)
Key Window Top C4 Key Window Top C7
Key Window Btm C2 Key Window Btm D4
1. Press the "4" button on the left-hand side of the keyboard. (It's also marked "Attack Gate"). This will
bring you screen 4A - "KW TOP" - This is the Key Window Top page. Here, you can see the Key
Window Top for the first four Timbres.
2. The third Timbre should be highlighted from selecting the channels on the previous screen. Press the
left directional button twice to highlight the first Timbre.
3. Using the value slider or YES/NO buttons, set the Key Window Top for the first Timbre to "C4".
4. Press the up directional button. This will take you to screen 1B - "KW BTM" - This is the Key Window
Bottom page.
5. Using the value slider or YES/NO buttons, set the Key Window Bottom for the first Timbre to "C2".
Now, the Piano (Timbre 2):
1. Press the down directional button once again, to get back to the Key Window Top screen.
2. Press the right directional button once to highlight the Key Window Top for the second Timbre.
3. Using the value slider or YES/NO buttons, set the Key Window Top for the second Timbre to "C7".
4. Press the up directional button once again, to get back to the Key Window Bottom page.
5. Using the value slider or YES/NO buttons, set the Key Window Bottom for the second Timbre to "D4".
And, finally, the Strings (Timbre 3):
1. Press the down directional button one more time, to get back to the Key Window Top page.
2. Press the right directional button once more to highlight the Key Window Top for the third Timbre.
3. Using the value slider or YES/NO buttons, set the Key Window Top for the third Timbre to "C7".
4. Press the up directional button once more, to get back to the Key Window Bottom page.
5. Using the value slider or YES/NO buttons, set the Key Window Bottom for the third Timbre to "D4".
You'll notice when you play that Bass is on the left hand exclusively, and the Piano and Strings are
doubled up on the right. Now that you have your Split/Layer Combination, all that's left to do is save
your work:
1. Press the "8" button on the left-hand side of the units (It's also marked "Effect Speed"). This will take
you to screen 8a - "Comb Write" - The Combination write screen.
2.
Press the right directional button once to highlight "OK?"
3. Press the YES button twice. This will permanently write your newly edited Combination.
Press the COMBI button to exit the Combination Edit mode.
Back to Top