Filter
Top Products
© 2002 by Krell Industries, Inc. All rights reserved P/N 306039
This product is manufactured in the United States of America. Krell
®
is a registered trademark of Krell
Industries, Inc., and is restricted for use by Krell Industries, Inc., its subsidiaries, and authorized agents. Krell
Current Mode™ is a trademark of Krell Industries, Inc. All other trademarks and tradenames are registered
to their respective companies.
Showcase 7
Showcase 6
Showcase 5
Multichannel Amplifier
Instructions for Use
v 02.1
Krell Industries, Inc.
45 Connair Road
Orange, CT 06477-3650 USA
TEL 203-799-9954
FAX 203-891-2028
E-MAIL krell@krellonline.com
WEBSITE http://www.krellonline.com
This product complies with the EMC directive (89/336/EEC) and the low-voltage
directive (73/23/EEC).
The amplifier must be placed on a firm, level surface where it is not exposed to
dripping or splashing.
The ventilation grids on the top, bottom, and sides of the amplifier must be unob-
structed at all times during operation. Do not place flammable material above or
beneath the amplifier.
Contact your authorized Krell dealer, distributor, or Krell before using any devices
designed to alter or stabilize the AC power for the Showcase Amplifier.
Before connecting the Showcase Amplifier, make sure the amplifier is turned off
and any output device (such as a preamplifier) is in mute or stand-by mode. Make
sure all cable terminations are of the highest quality and free from frayed ends,
short circuits, or cold solder joints.
Use only one input to each amplifier channel at a time.
If the red LED flashes when the amplifier is in the stand-by mode, unplug the
amplifier to reset the protection circuit. Check the loudspeakers and loudspeaker
cables for potential short circuits before reconnecting the amplifier to your system.
THERE ARE NO USER SERVICEABLE PARTS INSIDE THE PREAMPLIFIER
Please contact your authorized Krell dealer, distributor, or Krell if you have any ques-
tions not addressed in this reference manual.
CONTACT
INFORMATION
WARNINGS