Filter
Top Products
1. Input: ¼-inch 2-conductor input jack that is intended for electric guitar but will accept other instruments as well.
2. Gain (Lead): Adjust this control clockwise to increase the amount of distortion. Use in its lower ranges to produce less
distorted tones. As you increase the amount of gain, the tonality will shift from a classic rock-type sound to a heavier,
modern tone.
3. Volume (Lead): This controls the overall volume level of the Lead channel only.
4. Channel: This switch selects between the Lead and Rhythm channels.
5. Volume (Rhythm): This controls the overall volume level of the Rhythm channel only.
6. Bass: This controls the bass frequencies for both channels. This passive control adjusts frequencies at 100 Hz
and below.
7. Middle: This controls the middle frequencies for both channels. This passive control adjusts frequencies between 1
and 1.5 kHz.
8. Treble: This controls the treble frequencies for both channels. This passive control adjusts frequencies at 3 kHz
and above.
9. Reverb/Delay: This switch selects between Reverb and Delay effects. Press switch in to choose Delay.
10. Effects Level: This control increases the effect signal level and mixes it with the instrument’s signal. Turn the control
clockwise to add the desired level of effects.
11. Aux In: This is a 3-conductor, 1/8-inch, stereo jack that allows playback from a Compact Disc, MP3 player or other
audio device. The overall volume level will be determined by the audio device, so start with lower volume levels and
increase as needed.
12. Headphones: This is a 3-conductor, 1/8-inch input jack intended for headphone use. The amplier’s internal speaker
is disconnected when this jack is used.
13. Power Switch: This dual-function component is both an On/Off power switch and a status indicator light. When
illuminated, it shows that your amplier is ready to be played. To turn amplier on, press switch upward. To turn amp off,
press switch downward.
1
2
3
4
6
7
8
kustom.com
5
9 10 11 12 13
KG112FX Control Panel