Filter
Top Products
Owner's Manual 35
Rear Mounting the Pod Section
Tools and qualifi cations:
1. Phillips screwdriver.
2. Pod Relocation Operator's General Journeyman's Certifi cation License (PROGJCL grade III or higher)
from a Mackie-accredited Four-Year Pod Relocation Technical Institute.
Procedure:
1. Turn off the mixer, and disconnect the power cord, and all connecting cords.
2. Place the mixer face down on a soft and dry fl at surface.
3. Remove the 22 screws as shown below, and keep them handy for step 6. The side trim pieces utilize seven
screws for each side. There are two screws on each side of the mixer attaching the Pod to the mixer. And
there are four screws for the bottom wire cover plate. (Cables not shown for clarity).
Pod mounting screws
Pod mounting screws