Filter
Top Products
5
USD201-2
Symbols
The followings show the symbols used for tool.
･ volts
･ amperes
･ hertz
･ alternating current
･ no load speed
･ Class II Construction
･ revolutions or reciprocation per minute
FUNCTIONAL DESCRIPTION
WARNING:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking
function on the tool. Failure to switch off and
unplug the tool may result in serious personal injury
from accidental start-up.
Switch action
1
012768
CAUTION:
• Before plugging in the tool, always check to see
that the tool is switched off.
To start the tool, slide the slide switch toward the "I (ON)"
position.
To stop the tool, slide the slide switch toward the "O
(OFF)" position.
Adjusting the orbital stroke rate
1
012852
The orbital stroke rate is adjustable. To change the orbital
stroke rate, turn the dial between 1 and 5. The higher the
number is, the higher the orbital stroke rate is. Preset the
dial to the number suitable for your workpiece.
NOTE:
• The dial cannot be turned directly from 1 to 5 or
from 5 to 1. Forcing the dial may damage the tool.
When changing the dial direction, always turn the
dial moving it through each intermediate number.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the orbital stroke rate
is kept constant even under load condition.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing application tool
(optional accessory)
WARNING:
• Do not install application tool upside down.
Installing application tool upside down may damage
the tool and cause serious personal injury.
• Install attachment tool in the correct direction
according to your work. Application tool can be
installed at an angle of every 30 degree.
1
3
2
012888
1. Application tool
installation bolt
2. Holes in the
application tool
3. Protrusions of
the tool flange
1. Dial
1. Slide switch