Filter
Top Products
Specifications are subject to change without notice.
Mark Levinson
®
is aregistered trademark of
Harman International Industries, Incorporated.
Not responsible for typographic errors.
Part # 072-16155
Nº390SCDProcessor
Frequency Response: 10Hz - 20kHz, +0dB, -0.3dB
Total Harmonic Distortion:
(THD) 0.002% @ 1kHz, 0dBFS (10Hz - 30kHz)
Dynamic Range: 96dB (10Hz - 30kHz)
Signal-to-Noise Ratio: 105dB (10Hz - 30kHz)
Channel Separtion: Better than 110dB
Intermodulation Distortion:
(SMPTE IMD) Less than 0.005%
Maximum Output: 4.45V balanced
(0 dBFS signal) 2.225V single-ended
Volume Control:
(attenuation) Range 61.2 to +12dB
Digital-to-Analog
Conversion: Dual differential 24-bit DACs
Conversion Rate: 352.8kHz or 384kHz (input signal dependent), 24-bit
Analog Filter: Bessel-tuned, linear phase to 40kHz
Low-level Linearity: Deviation less than 2dB to below -90dBFS less than 2dB to below -102dBFS w/20-bit input
Output Impedance (analog): 10Ω
Direct Digital Output, XLR: AES/EBU 110Ω, 3.5V
Direct Digital Output, RCA: S/PDIF 75Ω, 0.5V
Mains Voltage: 100V, 120V, 200V, 220V, 240V, factory set for destination country
Mains Frequency: 50 or 60Hz, factory set for destination country
Power Consumption: 36 watts maximum
Overall dimensions: width: 15.75" (40cm)
height: 3.84" (9.75cm)
depth: 14.3" (36.3cm)
20.56" (52.21cm) with loader open
Input Complement: (1) EIAJ digital input
(1) S/PDIF (RCA) digital input
Output Complement: (2) male XLR balanced audio outputs
(2) RCA single-ended audio outputs
(1) AES/EBU (XLR) digital output
(1) S/PDIF (RCA) digital output
Other I/O: (2) RJ-45 modular Communication Links
(1) 3.5mm external IR input jack
(1) IEC AC mains connector
Shipping Weight: 50lbs (23kg)
3 Oak Park, Bedford, MA 01730-1413 USA
Tel: 781-280-0300 | Fax: 781-280-0490
www.marklevinson.com