Filter
Top Products
29
CAUTION!: TO REDUCE THE RISK OF FIRE REPLACE FUSES WITH THE SAME
TYPE AND RATING ONLY. DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE.
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
.
ATTENTION!: POUR EVITER LES RISQUES D’INCENDIE UTILISER UN FUSIBLE
DE MEME TYPE ET DE MEME CALIBRE. DEBRANCHER AVANT DE REMPLACER LE
FUSIBLE. POUR EVITER LES RISQUES DE DECHARGES ELECTRIQUES, NE PAS
OUVRIR LE COUVERCLE. CET APPAREIL NE COMPORTE AUCUNE PIECE
SUSCEPTIBLE D’ETRE REPAREE PAR VOS SOINS. FAITES TOUJOURS APPEL A
UN TECHNICIEN QUALIFIE POUR TOUTE REPARATION.
WARNING!: SHOCK HAZARD. DO NOT OPEN. TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
THIS APPARATUS MUST BE EARTHED.
AVIS!: RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR. POUR EVITER LES
RISQUES D’INCENDIE ET DE DECHARGES ELECTRIQUES, N’EXPOSEZ JAMAIS CET
APPAREIL A L’HUMIDITE OU A LA PLUIE. CONNECTER CET APPAREIL A LA TERRE.
EFFECTS LOOP AEFFECTS LOOP BLOUDSPEAKER OUTPUTS
EMULATED
LINE OUT
LOOP
LEVEL
LOOP
LEVEL
SEND
MAINS INPUT
120V ~ 60 Hz
375 Watts
MAINS FUSE
(T2A - 230V)
(T4A - 120V)
HT FUSE
T1A
RETURN16 Ohm ONLY SENDRETURN(4 & 8 Ohm PARALLEL JACKS)
8 Ohm 4 Ohm
SELECT
Note:
16 Ohm Output Jack negates use of others.
REFER TO MANUAL FOR FULL DETAILS. SE REFERER AU MANUEL POUR PLUS DE DETAILS.
Made in England by:
Marshall Amplification plc, Bletchley, Milton Keynes, England.
!
WARNING!: RISK OF HAZARDOUS ENERGY! AVIS!: ENERGIE ELECTRIQUE DANGEREUSE!
FOOT CONTROLLER
LOOP MODE
{
1 - Use EFFECTS LOOP A only as Master Loop (on all three channels)
2 - Use EFFECTS LOOP B only for effects on OD channels (CRUNCH & LEAD) only
3 - Use EFFECTS LOOPS A and B for separate effects on CLEAN & OD channels
CAUTION!: TO REDUCE THE RISK OF FIRE REPLACE FUSES WITH THE SAME TYPE
AND RATING ONLY. DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE.
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
ATTENTION!: POUR EVITER LES RISQUES D’INCENDIE UTILISER UN FUSIBLE DE
MEME TYPE ET DE MEME CALIBRE. DEBRANCHER AVANT DE REMPLACER LE FUSIBLE.
POUR EVITER LES RISQUES DE DECHARGES ELECTRIQUES, NE PAS OUVRIR LE
COUVERCLE. CET APPAREIL NE COMPORTE AUCUNE PIECE SUSCEPTIBLE D’ETRE
REPAREE PAR VOS SOINS. FAITES TOUJOURS APPEL A UN TECHNICIEN QUALIFIE POUR
TOUTE REPARATION.
WARNING!: SHOCK HAZARD. DO NOT OPEN. TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
THIS APPARATUS MUST BE EARTHED.
AVIS!: RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR. POUR EVITER LES RISQUES
D’INCENDIE ET DE DECHARGES ELECTRIQUES, N’EXPOSEZ JAMAIS CET APPAREIL A
L’HUMIDITE OU A LA PLUIE. CONNECTER CET APPAREIL A LA TERRE.
EFFECTS LOOP A EFFECTS LOOP B LOUDSPEAKER OUTPUTS
EMULATED
LINE OUT
LOOP MODE
{
1 - Use EFFECTS LOOP A only as Master Loop (on all three channels)
2 - Use EFFECTS LOOP B only for effects on OD channels (CRUNCH & LEAD) only
3 - Use EFFECTS LOOPS A and B for separate effects on CLEAN & OD channels
LOOP
LEVEL
LOOP
LEVEL
SEND RETURN 16 Ohm ONLYSEND RETURN (4 & 8 Ohm PARALLEL JACKS)
4 Ohm 8 Ohm
SELECT
Note:
16 Ohm Output Jack negates use of others.
REFER TO MANUAL FOR FULL DETAILS. SE REFERER AU MANUEL POUR PLUS DE DETAILS.
MAINS INPUT
120V ~ 60 Hz
375 Watts
HT FUSE
T1A
MAINS FUSE
(T2A - 230V)
(T4A - 120V)
Made in England by:
Marshall Amplification plc, Bletchley, Milton Keynes, England.
WARNING!: RISK OF HAZARDOUS ENERGY!
AVIS!: ENERGIE ELECTRIQUE DANGEREUSE!
!
FOOT CONTROLLER
Rear Panel - TSL122 Combo
Rear Panel - TSL100 Head
Diagram D - Rear Panels
5
1
2 6
5
1236
3
4
4