Filter
Top Products
Programming CueMixer Functions
CueMixer Setup 15
User A Mode 19
CueMixer Setup
By default the LX-300 connection to CueMixer is not enabled. An External Subcue is used to enable the connection
to a CueMixer.
When the LX-300 is first powered up, the CueMixer is not enabled. You must enable it by using the CueMixer RIF-
108 > Enable RIF command in the Frame Control window, or by programming an External Subcue.
From CueStation you can disable controls on the CueMixer. This can be used to restrict the control available to the
operator. The following external subcue commands control what CueMixer functions are enabled. By default, all
controls are enabled unless you use one of these commands to specifically disable them.
Important
After creating the subcues described in this section, you must then recall the subcue before the changes will go into
effect.
15