Milwaukee M18 Recording Equipment User Manual


  Open as PDF
of 8
 
5
ASSEMBLY
WARNING Rechargeonlywiththe
chargerspeciedforthebattery.Forspecic
charginginstructions,readtheoperator’s
manualsuppliedwithyourchargerandbattery.
AccessoryArbor
Type
Useadapterwiththisside
facingaccessory
adapter not needed
adapter not needed
adapter not needed
adapter not needed
* Adapter kit available as an
accesory. Always use installation
guard and accessory bolt
provided with the kit when using
these accessories.
Inserting/RemovingtheBattery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
To insert the battery, slide the pack into the body of
the tool. Make sure it latches securely into place.
ChangingAccessories
1. Remove the battery pack.
2. Lift the quick release lever and
push it rmly forward over the
detent.
3. Place the tool upside down on
a at surface.
4. Unscrew the accessory bolt.
5. Remove any accessories and
adapter.
6. Clean bolt, flange, adapter
and accessories of all dirt and debris.
7. Place the adapter (if necessary), accessory and
bolt onto the tool. Determine the need for an
adapter by using the chart. Hand tighten securely.
8. Press the quick release lever back into place.
Typical
Accessory
Assemblies
1
2
 previous next