Filter
Top Products
MT-76D2 TAMPING RAMMER —OPERATION AND PARTS MANUAL — REV. #5(11/08/07) — PAGE 9
■
ALWAYS stop the engine before servicing, adding fuel and
oil.
■
NEVER run engine without air filter. Severe engine may
occur.
■
ALWAYS service air cleaner frequently to prevent carburetor
malfunction.
■
ALWAYS check the machine for loosened threads or bolts
before starting.
■
ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using rammer.
■
ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of
the reach of children.
■
DO NOT operate this equipment unless all guards and
safety devices are attached and in place.
■
CAUTION must be exercised while servicing this equipment.
Rotating and moving parts can cause injury if contacted.
■
Keep all
inexperienced
and
unauthorized
people away
from the equipment at all times.
■
Unauthorized equipment modifications will void all
warranties.
■
NEVER pour or spray water over the engine.
■
Test the engine ON
/OFF
switch before operating. The
purpose of this switch is to shut down the engine of the
rammer.
■
Refer to the
Yanmar Engine Owner's Manual
for engine
technical questions or information recommended by
Multiquip for this equipment.
TRANSPORTING
■
ALWAYS shutdown engine before transporting.
■
Tighten fuel tank cap securely and close fuel cock to
prevent fuel from spilling.
■
Drain fuel when transporting rammer over long distances
or bad roads.
■
When placing the rammer inside a truck-bed for transport,
always tie-down the rammer
MAINTENANCE
■
NEVER lubricate components or attempt service on a
running rammer.
■
ALWAYS allow the rammer a proper amount of time to
cool before servicing.
■
Keep the rammer in proper running condition.
■
Fix damage to the rammer immediately and always
replace broken parts.
■
Dispose of hazardous waste properly. Examples of
potentially hazardous waste are used motor oil, fuel
and fuel filters.
■
DO NOT use food or plastic containers to dispose of
hazardous waste.
MT-76D2 TAMPING RAMMER — RULES FOR SAFE OPERATION
■
In emergencies
always
know the location of
the nearest phone or
keep a phone on the job
site
. Also know the phone numbers of the
nearest
ambulance
,
doctor
and
fire
department
. This information will be invaluable
in the case of an emergency.
EMERGENCIES
■
ALWAYS know the location of the nearest
fire
extinguisher
and first aid kit.