Multiquip WM120PH Music Mixer User Manual


 
WM120PH/SH HYDRAULIC MIXER • OPERATION AND PARTS MANUAL — REV. #7 (09/15/11) — PAGE 17
MIXER COMPONENTS/HYDRAULIC COMPONENTS
17. Adjustable Stabilizer Jack Stands — Use these jack
stands (3) to adjust the mixer to the desired height.
18. Forklift Pockets — When lifting of the mixer is required,
use these fork lift pockets to lift the mixer. Remember
to insert the forks of the forklift a minimum of 24 inches
into the lift pockets.This feature is only available on
the stationary mixer model.
HYDRAULIC COMPONENTS
Figure 5 illustrates the hydraulic components used on the
mixer.
1. Hydraulic Motor — Bi-directional hydraulic motor that
is used in conjunction with the directional control valve
to operate the hydraulic dump cylinder and paddle shaft.
2. Hydraulic Dump Cylinder — When activated, this
cylinder will cause the mixing drum to rotate to the
dump position.This cylinder is provided only on mixers
with
hydraulic dump
capability only.
3. Hydraulic Oil Sight Gauge — This gauge indicates
the level and temperature of the hydraulic oil. For normal
operation oil level should be visible at the midpoint on
the sightglass.
4. Hydraulic Valve — Directional hydraulic control valve.
Controls the direction of hydraulic fluid supplied to the
dump cylinder and paddle shaft.
Figure 5. Hydraulic Components
5. Hydraulic Dump Lever — This lever is provided on
mixers with
hydraulic dump
capability only. Pull lever
outward to activate dump cylinder.
6. Hydraulic Paddle Blade Lever — 3-position lever.
Push inward for clockwise mixing rotation of blades.
Place in center position for no rotation (neutral/off).
7. Pump — Supplies hydraulic fluid to the hydraulic
control valve.
8. Hydraulic Oil Filter — 10 micron hydraulic filter. Filters
out small particles that are harmful to the hydraulic
system.
9. Strainer — Filters out large particles and debris that
are harmful to the hydraulic system.
17
18
Figure 4. Mixer Components (Stationary)
Figure 5 shows configuration for electric motor.
Gasoline engine is configured in the same
manner.