Multiquip WM120PM Music Mixer User Manual


 
PAGE 12 — WM120PM/SM— OPERATION AND PARTS MANUAL — REV. #7 (09/15/11)
WM-120P/S — ELECTRIC MOTOR
ELECTRIC MOTOR
For lubrication care and operation of the electric motor, refer to
your electric motor instruction booklet furnished with the motor.
Protect the electric motor from dust as much as possible and
keep ventilating openings clean.
The electric motor for this mixer is available in either a 5 HP
single-phase or 5 HP 3-phase configuration. The input voltage
requirement for these motors is either 230 VAC or 440 VAC only.
ELECTRIC MOTOR CONNECTION
A 12 inch electrical cable (Figure 2) with a pigtail at one end is
provided with the electrical motor for hookup to a power source.
Table 1. shows the required NEMA connector for the desired
motor horsepower rating. In addition, Table 2 also shows the
matching NEMA approved connector for the required extension
cord.
CAUTION:
DO NOT spray water at any time on the
electric motor
.
DO NOT operate electric motor in a
explosive environment.
NOTE
It is strongly recommended that all electrical wiring be
done by a
licensed electrician
. Special attention
should be given to the electric switch as well as the
over-and-under voltage protection devices as per
regulations set forth in the local electrical safety code
handbook.
Figure 2. Single Phase Electric Motor with 12 inch Pigtail Cable
noitamrofnIgniriWrotoMcirtcelE.2elbaT
rotoM
rewopesroH
gnitaR
esahPelgniS-tloV032
rotcennoCgulPAMENAMENgnitaM
rotcennoCelcatpeceR
PH3935049N/PP02-6
L045049N/PR02-6L
PH5745049N/PP03-6L845049N/PR03-6L