Filter
Top Products
WM120PH/SH HYDRAULIC MIXER • OPERATION AND PARTS MANUAL — REV. #7 (09/15/11) — PAGE 25
INITIAL START-UP (ELECTRIC)/OPERATION
STARTING THE ELECTRIC MOTOR
1. Using an adequate size extension cord (Table 7),
connect one end of the extension cord to the plug on
the electric motor, connect the other end to the power
source. Make sure the motor is configured for the
proper operating voltage.
2. To start the electric motor, press the
black
ON/START
switch (Figure 22).
When the drum lock lever is placed
horizontally, the drum will be maintained in
the vertical position as the paddles rotate.
This condition does not apply to models that
have hydraulic dump capability.
Figure 22. Electric Motor On/OFF Switch (Start)
OFF
STOP
ON
START
PRESS TO
START
MIXING
1. On the hydraulic valve, push lever inward (Figure 23)
for clockwise mixing rotation of blades.
2. The paddle shaft inside the drum should be rotating at
this time.
3. Add a small amount water to the mixing drum.
4. Lift the mixing bag compound onto the steel safety
grate over the bag cutter and let the contents fall into
the drum. Add more water if desired and mix compound
to desired consistency.
WARNING — Dump Handle Safety
ALWAYS
stand clear of the
dump
handle
when the mixer is operational.
Any binding of material between the
mixer blades and the drum will cause
the drum handle to quickly move and
could cause severe bodily harm.
Figure 23. Hydraulic Paddle Lever
Figure 24. Drum Lock Lever
gnitaR)tnerruC(erepmAdaoL.7elbaT
)noisnetxEØ3(
htgneLdroC
)m(tf
2-05-27-501-721-0151-2102-51
)m0.3(tf01 ag21
)m6.7(tf52ag61ag61ag61ag61ag41ag41
)m2.51(tf05ag61ag61ag61ag4
1ag41ag21
)m5.03(tf001ag61ag61ag41ag21ag21
)m7.54(tf051ag61ag41ag21ag21
)m0.16(tf002ag41ag41ag21ag01
”YTUDYVAEH-ARTXE“ro”YTUDYVAEH“detarebtsumsdrocnoisnetxE
.htgnelsuounitnocaebtsumdna
5. Manual dump machines only: When mixing plaster or
mortar, the
drum lock lever
(Figure 24) should be in
the horizontal (down) position. (Does not apply to
hydraulic dump mixers.)