Nady Systems 401XQUADLTE4F Microphone User Manual


  Open as PDF
of 12
 
8
opeRaTIon
WGT Instrument Bodypack Transmitter
1. Snap open the BATTERY COMPARTMENT (25) and insert a fresh 9V BATTERY (26), observing the correct
polarity.Closethecompartment.TheWGT-15isprovidedwitha3.5mm
LOCKING JACK (27) for
connecting the
INSTRUMENT CABLE (28). To secure the connection, turn the metal slip ring on the
plugclockwisetothreaditontothejack.Tounplug,reversetheprocess.Slipthetransmitter
into a pocket or clip on to your clothes or instrument strap.
[Note: As the cord to the instrument also serves as the antenna, be sure to extend it fully for
maximum range. Rolling up or shortening the cord may reduce the effective operating range.]
2.TurnontheWGTbyslidingthe
OFF/STANDBY/ON SWITCH (29)totheSTANDBYposition(transmitter
on,audiomuted)ortheONposition(transmitterandaudiobothon).The
BATTERY INDICATOR LED
(30)
willgiveasinglequickash,indicatingusablebatterystrength.Inthecaseofadeadorlow
battery, the LED either will not go on at all or will stay on continuously, indicating that the battery
should be replaced with a fresh one.
3.TheWGTtransmitterisnowreadytouse.The
TX DISPLAY LEDs (7) on the 401X QUAD receiver
shouldnowbelit,indicatingareceivedsignalfromthetransmitter.Adjustthevolumeofthe
receiver as per the Audio Output Instrument Connections section of the above 401X QUAD
receiver instructions. The
AF LEVEL LED DISPLAY (7) on the 401X QUAD receiver will light up as if
theinputsignalsaregettingstronger.OccasionalickeringonandoffduringuseoftheLED
indicator is normal. However, if the LED stays on continuously, turn down the instrument volume
control or noticeable distortion may result. For ultra high-gain instrument sources such as active
basspickupsorevenextrahotguitarpickups,anattenuationpadmayberequiredtoeliminate
unwanted distortion.
[Note: The
INPUT LEVEL CONTROL (31) is not operable because it is preset and switched internally
at the factory to instrument GT input mode. The control is only used for Headworn Mic (HM)
and Lavalier (LT) input modes.]
[Note: Scratchy noises can sometimes occur when some electric guitars/basses with dirty pots
or connections are used with any wireless system. For this reason, the supplied
INSTRUMENT
CORD (28)
has a factory installed capacitor inside the ¼” plug. This capacitor provides first order
filtering of the RF signal from the cord into the guitar and eliminates virtually all scratchy noises.
Should your equipment still produce scratchy noises, we suggest these steps to eliminate them:
1)Makesureallguitarvolumeandtonepotsarecleanandallcontactsaresolid—
this is very important.
2)Provideextralteringwitha220pFcapacitorsolderedacrossthehottogroundterminals
oftheguitar’svolumeandtonepots.)
 previous next