Filter
Top Products
4
Handheld Microphone Transmitter
1. Unscrew the BATTERY COMPARTMENT
COVER (8) and remove. Insert a fresh
9V BATTERY (9), observing correct polarity
as marked, and screw the cover back on
to the microphone. To ensure proper battery
contact, the cover must be screwed on
completely.
2. Turn on the handheld mic by sliding the
OFF/ON SWITCH (10) to the “On” position.
The BATTERY INDICATOR LED (11) will give a
single quick flash, indicating usable battery
strength. In the case of a dead or low
battery, the LED will either not go on at all or
will stay on continuously, indicating that the
battery should be replaced with a fresh one.
3. The microphone is now ready to use.
The corresponding RX LED (7) on the DKW-3
receiver should now be lit, indicating
a received signal from the transmitter.
Adjust the VOLUME (6) control of the
receiver channels you are using clockwise
to about
3
/
4
rotation, until the volume level
is comfortable for your application.
Note: Observe care in selecting P.A. volume,
transmitter location and speaker placement so
that acoustic feedback (howling or screeching)
will be avoided.
11 10 9 8