Filter
Top Products
6
HT-8U Handheld Mic Transmitter
1. Release the BATTERY COVER (9) by
pressing the locking tab and slide down
as per the arrow, exposing the BATTERY
HOLDER (10). Insert two fresh AA alkaline
or NiMH batteries, observing the correct
polarity as marked, and slide the battery
cover back on to the microphone. Make
sure the cover is closed completely. Fresh
alkaline batteries can last up to 10 hours
in use, but in order to ensure optimum
performance, it is recommended that you
replace the battery after every 6-8 hours
of use. NiMH batteries should be replaced
with fresh ones recharged fully (with
separate charger, not supplied, and as per
its charging instructions) whenever low or
dead battery status is indicated as per the
following.
2. Turn on the HT-8U by sliding the OFF/
STANDBY/ON SWITCH (11) to the STANDBY
position first (transmitter on, audio muted)
or the ON position (transmitter and audio
both on). The BATTERY INDICATOR LED (12)
will give a single quick flash, indicating
usable battery strength. In the case of a
dead or low battery, the LED will either not
go on at all or will stay on continuously,
indicating that the batteries should be
replaced with fresh ones. To preserve
battery life, turn the transmitter off when
not in use.
3. The microphone is now ready to use.
The SIGNAL LED (5) on the DKW-8U receiver
should now be lit, indicating a received
signal from the transmitter. When ready to
speak, slide the OFF/STANDBY/ON SWITCH
(11) to the ON position. Adjust the volume
of the receiver as per the Connecting
the Audio Output of the above DKW-8U
receiver instructions.
[Note: Observe care in selecting P.A. volume,
transmitter location and speaker placement so
that acoustic feedback (howling or screeching)
will be avoided.]
9
11 12
Back
Front
10