Filter
Top Products
4
Handheld Microphone Transmitters
1. Unscrew the BATTERY COMPARTMENT
COVER (8) and remove. Insert a fresh
9V BATTERY (9), observing correct polarity
as marked, and screw the cover back on
to the microphone. To ensure proper battery
contact, the cover must be screwed on
completely.
2. Turn on the handheld mic by sliding the
OFF/ON SWITCH (10) to the “On” position.
The BATTERY INDICATOR LED (11) will give a
single quick flash, indicating usable battery
strength. In the case of a dead or low
battery, the LED will either not go on at all or
will stay on continuously, indicating that the
battery should be replaced with a fresh one.
3. The microphone is now ready to
use. The corresponding RX LED (7) on
the DKW-Duo receiver should now be
lit, indicating a received signal from the
transmitter on that Channel (1,2). Adjust the
VOLUME (6) control of the receiver channels
you are using clockwise to about
3
/
4
rotation,
until the volume level is comfortable for your
application. If using both CH 1 and CH 2,
adjust the relative volume of each channel
as desired in the mixed (summed) receiver
AUDIO OUT (5).
Note: Observe care in selecting P.A. volume,
transmitter location and speaker placement so
that acoustic feedback (howling or screeching)
will be avoided.
11 10 9 8