Nady Systems ENCORE1LTOB Microphone User Manual


  Open as PDF
of 16
 
5
5. Connecting the Audio Output
TheEncoreIreceiverprovidesbothaxedmiclevelBALANCED AUDIO OUTPUT XLR
(14)andanadjustablelinelevelUNBALANCED AUDIO OUTPUT 1/4” JACK (13). The level
from the UNBALANCED OUTPUT is controlled by the rear panel VOLUME CONTROL (6).
(Note: As when making any connection, make sure the amplier or mixing board
volume is at the minimum level before plugging in the receiver to avoid possible
sound system damage. Also make sure that the phantom power on the input of
the mixer is turned OFF before making connection to the receiver.)
a. Instrument Connection (using the WGT instrument transmitter)
Insert an audio cord with a 1/4" mono phone plug in the A + B
UNBALANCED OUTPUT JACK (13) on the rear panel of the receiver. Plug the
otherendofthecordintoanamplier,effects,ormixingboard.Adjustthe
appropriate VOLUME CONTROL (6) for the channel being used on the Encore I
receiverclockwisetoabout3/4rotation,untilthemixedvolumelevelis
comfortable for your application. This setting is roughly equivalent to a direct
instrumentcordconnection.Turningthevolumeuptomaximumwillprovide
4dB gain over a cord.
b. Microphone Connection (using the WLT transmitter with either a headset
or lavalier microphone or the WHT handheld microphone transmitter)
For microphone use, either the BALANCED MIC AUDIO OUTPUT XLRs (14) or the
1/4" line level A + B UNBALANCED OUTPUT (13)canbeused.TheXLRoutput
issetatanon-adjustablemicrophonelevel,similartohardwiredmiclevels.
PluganXLRconnectorintoeitherorbothoftheXLR OUTPUT JACKS on the
rearoftheunitandplugtheotherendintoyouramplierormixingboard.
(Note: Make sure the phantom power on your mixing board is turned off
and the volume is turned down when making connections.)
Foryourconvenience,theXLRoutputlevelsarepresetatthefactoryand
arenotadjustablewiththereceivervolumecontrols.Tousethe1/4" A + B
UNBALANCED OUTPUT JACK (13), follow the instructions for the Instrument
Connection(above),exceptstartwiththereceivervolumeat1/2MAX
andadjustthevolumecontrolforeachchanneluntilthemixedChAand
Ch B volume level is optimal. If the volume controls are set too high, you
mayoverloadyourmixeroramp.
 previous next