Nady Systems ENCORE2HTSYSB Microphone User Manual


  Open as PDF
of 16
 
1. Unscrew the BATTERY COMPARTMENT COVER (17) and remove, exposing the
BATTERY HOLDER (18). Insert a fresh 9V ALKALINE BATTERY (19), observing the
correct polarity as marked, and screw the cover back on to the microphone.
Make sure the cover is screwed on completely. A fresh alkaline battery can
last up to 16 hours in use, but in order to ensure optimum performance, it is
recommendedthatyoureplacethebatteryafterevery10hoursofuse.
2. Turn on the WHT by sliding the OFF/STANDBY/ON SWITCH (20) to the STANDBY
position (transmitter on, audio muted) or the ON position (transmitter and audio
both on). The BATTERY INDICATOR LED (21)willgiveasinglequickash,indicating
usable battery strength. In the case of a dead or low battery, the LED will either
not go on at all or will stay on continuously, indicating that the battery should be
replaced with a fresh one. To preserve battery life, turn the transmitter off when
not in use.
3. The microphone is now ready to use. The A and/or B DIVERSITY LED INDICATORS
(3) and most or all of the RF LEVEL DISPLAY LEDs (4) on the Encore II receiver
should now be lit, indicating a received signal from the transmitter. When ready
tospeak,slidethetransmitterswitchtotheONposition.Adjustthevolume
of the receiver as per the Audio Output Microphone Connection section of
the above Encore II receiver instructions. The AF LEVEL LED DISPLAY (5) on the
Encore II receiver will light up to 5 LEDs (4 green and 1 red) for all input signals.
OccasionalickeringonandoffduringuseofthetopredLEDindicatorinthis
display is normal, however if the red LED stays on continuously, it means the
signal is too loud and there is the possibility of overload distortion. Back off from
themicrophoneuntiltheredLEDindicatoronlyickersonpeaks.
[Note: Observe care in selecting P.A. volume, transmitter location and speaker
placement so that acoustic feedback (howling or screeching) will be avoided.]
[Note: Microphone elements can easily be destroyed by the buildup of salts and
minerals from perspiration and saliva. It is good practice to put a windscreen on
the mic element at all times to protect it.]
7
WHT HANDHELD MICROPHONE TRANSMITTER
 previous next