Nady Systems ENCOREDUETHTLTPR Microphone User Manual


  Open as PDF
of 16
 
1. Unscrew the BATTERY COMPARTMENT COVER (17)andremove,exposingthe
BATTERY HOLDER (18). Insert a fresh 9V ALKALINE BATTERY (19), observing the
correct polarity as marked, and screw the cover back on to the microphone.
Make sure the cover is screwed on completely. A fresh alkaline battery can
lastupto16hoursinuse,butinordertoensureoptimumperformance,itis
recommendedthatyoureplacethebatteryafterevery10hoursofuse.
2. Turn on the WHT by sliding the OFF/STANDBY/ON SWITCH (20) to the STANDBY
position(transmitteron,audiomuted)ortheONposition(transmitterandaudio
bothon).TheBATTERY INDICATOR LED (21)willgiveasinglequickash,indicating
usable battery strength. In the case of a dead or low battery, the LED will either
not go on at all or will stay on continuously, indicating that the battery should be
replaced with a fresh one. To preserve battery life, turn the transmitter off when
not in use.
3. The microphone is now ready to use. Most or all of the RF LEVEL DISPLAY LEDs (4)
on the Encore DUET receiver should now be lit, indicating a received signal
from the transmitter. When ready to speak, slide the transmitter switch to the ON
position.AdjustthevolumeofthereceiveraspertheAudioOutputMicrophone
Connection section of the above Encore DUET receiver instructions. The AF LEVEL
LED DISPLAY (5)ontheEncoreDUETreceiverwilllightupto5LEDs(4greenand
1red)forallinputsignals.Occasionalickeringonandoffduringuseofthe
top red LED indicator in this display is normal, however if the red LED stays on
continuously, it means the signal is too loud and there is the possibility of overload
distortion.BackofffromthemicrophoneuntiltheredLEDindicatoronlyickers
on peaks.
[Note: Observe care in selecting P.A. volume, transmitter location and speaker
placement so that acoustic feedback (howling or screeching) will be avoided.]
[Note: Microphone elements can easily be destroyed by the buildup of salts and
minerals from perspiration and saliva. It is good practice to put a windscreen on
the mic element at all times to protect it.]
7
WHT HANDHELD MICROPHONE TRANSMITTER
 previous next