Filter
Top Products
4
INSTALLATION & OPERATION
Please read this manual thoroughly before using.
INSPECTION
Your MaxTower was carefully packed at the factory in packaging designed to
protect the unit in shipment. Before installing and using your unit, carefully
examine the packaging and all contents for any signs of physical damage
that may have occurred in transit.
CONTENTS
• Instruction manual
• MaxTower PAS-250 (verify unit’s serial number is same as shown on
shipping carton)
• AC power cord
• Tripod speaker stand
• Nylon carrying bag
SETTING UP
The MaxTower and stand fit securely in the supplied padded bag.
• Open the bag and remove the stand.
• Loosen the knobs, set up the stand, select height.
• Insert the metal pin through the stand.
• Tighten the knobs to secure.
• Remove MaxTower from the padded bag.
• Place MaxTower on stand securely through bottom mounting hole.
• Plug the AC power cord into the rear panel jack (11), then power cord
into a nearby power outlet. The MaxTower has an internal power
supply and is designed to operate from an external AC source (Power
Range: AC l00~240V, 50/6OHz (+/— 10%). Make sure that the unit is
turned off before connecting to the AC power source to avoid possible
loud transients that can damage your speakers or your ears, especially
when monitoring with headphones.
• Turn on unit with Power ON/OFF Switch (13) on rear panel. The
Power On LED (1) will light.
• Plug in mic or instrument, make any necessary adjustments, setting
channel gain, EQ, and reverb.