Filter
Top Products
CONTROLS AND CONNECTORS
5
FRONT PANEL
(4)
Front Panel
(1) POWER SWITCH
Use this switch to power unit ON or OFF. The integrated LED will
light when the unit is ON. Before turning on this unit, verify
connection to the proper voltage AC source, check all connections
and turn down the level controls of equipment connected to the
outputs.
(2) BASS & TREBLE TONE CONTROLS
Adjust the relative balance of bass and treble
Rear Panel
(5) AC POWER CORD IEC CONNECTOR WITH INTEGRATED
FUSE HOLDER
This standard IEC power cord receptacle is used to connect the
AC power to your unit. It features a built-in fuse holder for a
5X20mm, 0.5A/250V slow-blow fuse. If the fuse continuously
blows, shut of the unit and have it serviced by qualified service
personnel.
(6) AC VOLTAGE SELECT SWITCH
Before plugging in the power cord, check to see that the unit is
set for the proper voltage for your area: ~115V (60Hz) or ~230V
(50Hz).
(Note: Use at the improper voltage can damage your unit and
void the warranty.)
(7) HIGH/LOW OUTPUT LEVEL SELECT SWITCH
Selects either high or low output so the level can be optimized for
the connected audio equipment (amp, recording device, etc.)
(1)(2)(3)
REAR PANEL
(3) MASTER LEVEL CONTROL
Adjusts the master level of the combined individual channel signals
(4) CHANNEL GAIN CONTROLS
Adjust the individual (1-6) channel gains
(8) MIXER OUTPUTS
Unbalanced 1/4" (6.3mm) and balanced XLR outputs
(Note: Only one output (1/4" or XLR) can be used at one time. Do
not connect to both at the same time, or the signal will be severely
distorted.)
(9) MIXER INPUTS
Unbalanced 1/4"(6.3mm) and balanced XLR inputs for channels 1
through 6.
(Note: Channels 4, 5 and 6 provide +15V phantom power for
condenser mics. These can be safely used with any balanced
dynamic mic also; however, do not connect any unbalanced
dynamic microphones to the XLR balanced inputs as they may be
damaged.)
(Note: Only one input per each channel (1/4" or XLR) can be used
at one time. Do not connect to both at the same time or the signal
will be severely distorted.)
(5) (6) (7) (8) (9)