Filter
Top Products
DM2002X
DM2002X REAR PANEL DIAGRAM...
REAR PANEL: INPUTS AND OUTPUTS
1
2
3 4 65
888
7 6 7 7
1. AC Connection. Plug your power cord in here.
See safety precautions on page 3 for proper treatment
of the power cord.
2. GND is the grounding lug for all turntables. Always
use this connection (your turntable cable should have a
grounding wire).
3. The Stereo Main Outputs are low-impedance
RCA connectors controlled by the Master fader.
4. The Stereo Booth/Zone Outputs are low-
impedance unbalanced RCA jacks controlled by the
Zone Level control.
5. Send Output is set by the send buttons pressed
on the front panel. Hook up you sampler or other
processor here.
6. Channels 2 and 3 Line Inputs are unbalanced
RCA jacks. The Line Input is selected with the toggle
switch on the front panel.
You can connect stereo audio from HiFi VCRs, cassette
and reel-to-reel tape decks, DAT machines, CD players,
laser discs, tuners, even synthesizers or other mixing
consoles.
NOTE: Plug mono audio sources into both Left and
Right inputs using a “Y” cable connector.
7. Phono Inputs on Channels 1, 2 and 3 use
unbalanced RCA jacks. Your input signal is fed directly
to the DM2002X's high-quality RIAA phono pre-
amplifiers so use this position only for moving magnet
cartridges. Line level sources will overload the sensitive
phono pre-amps and will sound very bad, so always be
sure to toggle the line/phono switch over to line before
connection of line sources.
8. Line/Phono Input switch. Use this to allow line
level equipment to be plugged into your phono inputs
giving you a total of 5 line input options.
Warning: make sure the LINE/PHONO input
switch is set to line before playing any line
input level devices through your mix
Numark - The Proven Leader in DJ Technology
©1997 Numark Industries 8 http://www.numark.com