Filter
Top Products
DM900EX
REAR PANEL: INPUTS AND OUTPUTS
(Please refer to diagram on page 7)
1. Power Input. Plug your external power supply into
here. See safety precautions on page 3 for proper
treatment of the power cord.
2. GND is the grounding lug for all turntables. Always
use this connection (your turntable cable should have a
grounding wire).
3. Phono Inputs on Channels 1, 2 and 3 use
unbalanced RCA jacks. Your input signal is fed directly
to the DM900's high-quality RIAA phono pre-amplifiers
so use this position only for moving magnet cartridges.
Line level sources will overload the sensitive phono pre-
amps and will sound very bad, so always be sure to
toggle the line/phono switch over to line before
connection of line sources.
4. Channels 1 & 2 Line Inputs are unbalanced
RCA jacks. The Line Input is selected with the toggle
switch on the front panel.
You can connect stereo audio from HiFi VCRs, cassette
and reel-to-reel tape decks, DAT machines, CD players,
laser discs, tuners, even synthesizers or other mixing
consoles.
NOTE: Plug mono audio sources into both Left and
Right inputs using a “Y” cable connector.
5. Line/Phono Input switch. Use this to allow line
level equipment to be plugged into your phono inputs
giving you a total of 8 line input options.
6. The Tape Outputs are low-impedance unbalanced
RCA jacks which output the program mix and allow you
to connect any recording device.
7. The Stereo Master Outputs are low-impedance
RCA connectors controlled by the Master fader.
Numark - The Proven Leader in DJ Technology
©1998 Numark Industries 8 http://www.numark.com