Filter
Top Products
DM 1885X
DM1885X REAR PANEL DIAGRAM...
1
2 34 5
6
7
8
9
10
12
777 7 99
8
11
1. The Balanced Main Outputs are low-impedance XLR
type connectors controlled by the Master fader.
2. The Stereo Main Outputs are low-impedance RCA
connectors controlled by the Master fader.
3. The Tape Outputs are low-impedance unbalanced RCA
jacks which output the program mix and allow you to
connect any recording device.
4. The Stereo Zone Outputs are low-impedance
unbalanced RCA jacks controlled by the Zone Level
controls.
5. The Send can be attached to an external effects
processor such as a sampler.
6. Mic is the mic input for the Mic Channel and Channel 4.
7. Channels 1-5 Line Inputs are unbalanced RCA jacks.
The Line Input is selected with the toggle switch on the
front panel. You can connect stereo audio from HiFi
VCRs, cassette and reel-to-reel tape decks, DAT
machines, CD players, laser discs, tuners, even
synthesizers or other mixing consoles.
NOTE: Plug mono audio sources into both Left and Right
inputs using a “Y” cable connector.
8. Line/Phono Input switch. Use this to allow line level
equipment to be plugged into your phono inputs giving
you a total of 8 line input options.
9. Phono Inputs on Channels 1, 2 and 3 use
unbalanced RCA jacks. Your input signal is fed directly to
the DM1885X's high-quality RIAA phono preamplifiers
so use this position only for moving magnet cartridges.
Line level sources will overload the sensitive phono
preamps and will sound very bad, so always be sure to
toggle the line/phono switch over to line before
connection of line sources.
10. AC Cord. See safety precautions on page 3 for proper
treatment of the power cord.
11. Voltage Selector. Set this for the appropriate voltage
in your area
12. GND is the grounding lug for turntables 1, 2 and 3
(phono inputs on Channels 1, 2 and 3). Always use this
connection (your turntable cable should have a
grounding wire).
Numark - The Proven Leader in DJ Technology
©1997 Numark Industries 12 http://www.numark.com