Filter
Top Products
View 1: Use allen wrench to secure string
Thread the other string end under the nut and into the small hole in the
corresponding machine head tuning post. Allow two inches of slack for
turning around the machine head post (View 2).
For the thicker strings (E, A, D), wrap the string end clockwise around
post, then run under string at post entry, and pull string tightly over
itself, creating a knot. Strings G, B and E should be wound and secured
in the same manner (counterclockwise on a three-a-side headstock, as
in View 2). To avoid slippage, wind strings tightly from top to bottom on
each post, completing 2- wraps around each post. Keep a light pressure
on the string with the ngers of your other hand while tightening the tuners. (An inexpensive, optional
peg winder makes winding much easier.) Tune strings to correct pitch, checking post wraps for smooth
winding. String ends can then be bent down and trimmed near the knot.
Because new strings are prone to stretch when rst installed, you should gently stretch the string by
pulling it away from the neck and retune again.
View 2: Insert string in machine head.
16 1
Double Locking Tremolo - Changing Your Strings
First, detune the 6th string (the thickest, top string) using the machine head tuner—two or three turns
should remove the tension on the string. Then, using a mm Allen wrench, unlock the corresponding
string clamp located at the nut. Then, back on the bridge, reset each Fine Tuner to its middle range.
Now, you are ready to remove the 6th string.
Using a mm Allen wrench, unclamp the 6th string at the saddle by loosening the saddle lock
screws at the rear of the tremolo. Remove string by sliding it out of the nut and unwrapping from the
tuning machine head. Note: Broken string pieces can be removed easily with tweezers or a magnetic
screwdriver.
Using wire cutters, remove the ball end and extra wrapping of the
replacement string. (New strings should be free of twists, kinks and
bends that can cause sound irregularities or breakage.) Insert the freshly
cut end of the string into the saddle; tighten the saddle lock screws at
the rear of the tremolo until snug (View 1). TIP: For easier access to the
tremolo screws, and to protect the nish of your guitar, tilt the rear of the
tremolo upward using an attached tremolo arm (whammy bar). Do not
overtighten the screws or you may permanently damage the saddles or
strip the Allen sockets.
Double Locking Tremolo - Changing Your Strings