Filter
Top Products
7
(23) CHANNEL SELECT
This switch selects the channel (Ultra or Rhythm). The active channel LED illuminates to indicate the active
channel.
(24) EFX ADJUST
Pressing this control selects the effect. A yellow LED adjacent to the effect name will illuminate to indicate the
selected effect. Rotating this control clockwise changes the parameter of the active effect according to the
descriptions below. The surrounding LED ring indicates relative value of the parameter being adjusted.
EFX ADJ PARAMETERS
Tremolo: Rate increase Funk wah: Sensitivity increase
Octaver: Wet/Dry mix Rotary Speaker: Rate increase
Flanger: Rate increase Phaser: Rate increase
Chorus: Rate increase/depth decrease
EFX amps are built with factory settings loaded into the presets. To return to the factory settings, first turn the
power to OFF. Then‚ press and hold both the EFX ADJUST (24) and DELAY (26) controls while turning the
amp back on.
(25) VOLUME BOOST
This control adjusts the level of Volume Boost. The surrounding LED ring indicates level.
(26) DELAY
This control adjusts delay type, time, and volume. Three types of delay are available: SLAP (1 repeat), ECHO
(3–4 repeats), or INFINITE (5–6 repeats). The LEDs in each section of the control indicate which type is active
and level. Pressing the control twice sets the delay time to the interval between presses.
Triple XXX
®
40 EFX
23 24 25 26