Filter
Top Products
1
2 3 4 5 6 7 8 9
10
11
12
This two-way switch applies mains power to the unit.
This two-way switch allows the amp to be placed in the STANDBY mode. In the STANDBY position the tubes
stay hot but the amplifi er is not operational. Switching to the ON position places the amp in active mode.
Adjusts the high-frequency damping factor of the power amplifi er, which gives the amp a "mellow" character
when fully counterclockwise and more of "biting" or forward character when rotated clockwise.
Adjusts the low-frequency damping factor of the power amplifi er, which gives the amp a "tighter" sound
when fully dialed counterclockwise and an increasingly "looser" sound when adjusted clockwise.
Adjusts the high-frequency damping factor of the power amplifi er, which gives the amp a "mellow" character
when fully counter-clockwise and more of "biting" or forward character when rotated clockwise.
Adjusts the low-frequency damping factor of the power amplifi er, which gives the amp a "tighter" sound
when fully dialed counter clockwise and an increasingly "looser" sound when adjusted clockwise.
Controls the amount of spring reverb in the signal chain.
This control adjusts the volume of the Lead channel.
This passive control regulates the high frequencies for the Lead channel.
This passive control regulates the mid frequencies for the Lead channel.
This passive control regulates the low frequencies for the Lead channel.
Adjusts the amount of gain in the Lead channel. Turning this knob clockwise will increase the amount of
distortion present in the signal.
This light is on when the Lead channel is active.
1
2
3
4
5
6
7
8
9
10
11
12
13
13