Filter
Top Products
String Installation
After loosening topnut screws (at headstock), use tuning
machines to remove string tension. Loosen string lock bolts
at bridge approximately three turns using the 3mm hex
wrench. Insert string end through tuning machines and
locking topnut. Cut off excess string length approximately
one inch past string of lock bolts. Insert string end into
bridge saddle (between saddle housing and lock block)
and tighten until snug. DO NOT OVERTIGHTEN. Adjust fine
tuning knobs to middle position. Stretch strings and tune
to pitch. Tighten locking topnut, stretch string once more
and fine-tune to pitch.
Tremolo Bridge Height
Bridge height may be adjusted by means of the bridge
pivot bolts. Turn the pivot bolts clockwise to reduce bridge
height. Turn the pivot bolts counterclockwise to increase
bridge height.
Tremolo Bridge Tension
The tension of the tremolo bridge is set by adjusting the
spring tension screws which hold the spring claw in place.
To gain access to the spring tension screws and spring
claw, remove the spring cover on the back of the guitar.
The instrument is equipped with two springs, which allow
proper tension for the string gauge supplied with the guitar.
The extra spring is enclosed should you prefer to use a heavi-
er string gauge.
Proper tremolo tension is achieved when the bottom of the
tremolo bridge plate rests on the top surface of the guitar
body without requiring excessive force to depress the
tremolo arm.
The tremolo can be adjusted to operate as a floating style
tremolo by loosening the spring tension. Turn the spring
tension screws clockwise to increase the spring tension,
and counterclockwise to decrease the spring tension.
This instrument should be tuned to proper pitch (A-440)
before and after making adjustments.
7