Filter
Top Products
2 Pelco Manual C917M (5/96)
4.0 SPECIFICATIONS
Dimensions: See Figure 1
Construction: 14 and 16-gauge steel
Weight: 4 lbs 10 oz. (2.08 kg)
5.0 INSTALLATION
The RMA131SU rack kit is supplied unassembled. The
following hardware is provided for use in assembling
the rack kit.
Qty Description
6 8-32 Hex nuts
6 #8 Lock Washers
To install the rack kit and monitor, perform the follow-
ing steps:
1. Assemble the rack as shown in Figure 2 using the
supplied hardware.
While assembling, install all hardware loosely un-
til all components are attached and then finish by
tightening all hardware.
2. Slide the monitor into the rack, tight against the
rear stop.
3. Install rack and monitor as an assembly into con-
sole and make any required electrical connections.
4. Hold into place, aligning mounting holes of the
RMA131SU with mounting holes in console, and
insert and tighten required fasteners (not supplied).
Figure 1. RMA131SU Dimension Drawing
NOTE: VALUES IN PARENTHESES ARE CENTIMETERS; ALL OTHERS ARE INCHES.