Filter
Top Products
PELCO Manual C985M - 1/94 2
4.0 INSTALLATION
The RM13 rack kit is supplied unassembled. The fol-
lowing hardware is provided for use in assembling the
rack kit.
Qty Description
6 10/32 Hex nuts
6 #10 Lock Washers
To install the rack kit and monitor, perform the follow-
ing steps:
1. Assemble the rack as shown in Figure 2 using the
supplied hardware.
While assembling, install all hardware loosely un-
til all components are attached and then finish by
tightening all hardware.
2. Slide the monitor into the rack, tight against the rear
stop.
3. Install rack and monitor as an assembly into con-
sole and make any required electrical connections.
4. Hold into place, aligning mounting holes of the
RMA13 with mounting holes in console, and insert
and tighten required fasteners (not supplied).