Filter
Top Products
8
CONNECTING MICROPHONE AND HEADPHONES
Microphone
The MIC 1 jack on the upper surface of the operating panel can be
used to connect a microphone with Ø6.3 mm phone plug or XLR
plug.
The MIC 2 jack on the upper surface of the operating panel can be
used to connect a microphone with Ø6.3 mm phone plugs.
¶ When the connection panel’s MIC SIGNAL switch is set to [CUT],
no microphone sounds will be output from the BOOTH monitor
output connectors.
¶ When using a microphone, set the operating panel’s MIC switch to
[ON] or [TALK OVER], and adjust the LEVEL dial as necessary.
When not using a microphone, it is recommended to set the MIC
switch to [OFF] and rotate the LEVEL dial fully counterclockwise to
the [- ∞] side.
Headphones
The PHONES jack on the upper surface of the operating panel can be
used to connect headphones with a Ø6.3 mm stereo phone plug.
0
+
6
-
12
MIC 1
LEVEL
MIC 1 MIC 2
0
HI
EQ
MIC
LOW
MIC
+
6
OFF ON TALK
OVER
-
12
MIC 2
LEVEL
Microphone 1
Microphone 2
(Microphone 1)
Headphones
HEADPHONES
MIXING
LEVEL
PHONES
MONO SPLIT STEREO
MASTERCUE
0
CONNECTIONS (CONNECTING MICROPHONE AND HEADPHONES/CONNECTING THE POWER CORD)
CONNECTING THE POWER CORD
Connect the power cord last.
÷ After completing all other connections, connect the accessory power cord to the AC inlet on the back of the player, then connect the plug to a
standard wall outlet or to the auxiliary power outlet of your amplifier.
÷ Use only the supplied power cord.