Filter
Top Products
DJS Ver. 1.601
3
1
Chapter 1 Controlling DJS
It is necessary to install the driver software before connecting a SEP-C1 to your
computer. Please do not connect the SEP-C1 to your computer until you have finished
installing the driver software.
For information on how to install the driver software, please refer to “ABOUT THE
DRIVER PROGRAM” in the Operating Instructions of your SEP-C1.
When 2 or more SEP-C1s are connected
If you connect two or more SEP-C1s to your computer, only the first SEP-C1 will be
able to operate DJS.
1-1 Connecting to your SEP-C1 to a computer
Connect the SEP-C1 to your computer with a USB cable and a USB auxiliary power cable. For
information on each of the cables that come with the SEP-C1 as well as each type of the SEP-C1’s
cable jacks, please refer to “CONNECTIONS” in the operating instructions of your SEP-C1.
1 Connect the 5V connector on the back of your SEP-C1 to the USB
port on your computer with a USB auxiliary power cable.
2 Connect the PC connector on the back of your SEP-C1 to the USB
port on your computer with a USB cable.
3 Start up your computer.
• It is also possible to start up your computer first and then make the connections to
your SEP-C1.
Warning!
Updating your Version of DJS
In order to use your SEP-C1 in conjunction with
DJS, it is necessary to update DJS to version
1.600 or later. Please refer to the DJS User’s
Manual for directions on how to update your
version of DJS.
→ ‘Using the Support Site’
Warning!
SEP-C1 Power Supply
The power for the SEP-C1 is supplied from a
USB port on your computer. Connect the USB
cable and USB auxiliary power cable directly to
your computer’s USB ports. Do not connect them
to a USB hub or any other kind of USB splitter.
Starting up DJS
Start up DJS after making the connections to the
of your SEP-C1.Also,take care to close DJS
before disconnecting of your SEP-C1.