Filter
Top Products
2. Dual Stereo Configurations
For systems without rear subwoofers, the user may prefer to use two
MaxxBass
®
Processors, one for the front speakers and one for the
rear speakers. The units should be wired between the in-dash CD
Receiver and the power amplifiers as shown below.
NOTE: As an option, before beginning, disconnect the
negative (-) terminal of the battery to prevent an
electrical short to ground. Reconnect the negative
terminal only after all connections have been made.
WIRING PROCEDURES
The next step is to connect the Power, Ground, and Remote IN/OUT
wires to your
MaxxBass
®
Processor. The power wire should run
from the mounting location through the vehicle to the battery or
power distribution block. Avoid sharp corners, creases, and sharp
body parts. When passing through any metal wall (i.e. firewall, etc.),
a grommet must be used to prevent the wire from chafing and
shorting to ground.
Front Rear
Maxx
Bass
®
In-dash
CD Receiver
Power
Amplifiers
Maxx
Bass
®
Front speakers
with Virtual
Subwoofer
TM
LF
RF
Rear speakers
with Virtual
Subwoofer
TM
RF
RR
10