Filter
Top Products
Bare Wire Connection Banana Plug Connection Spade Plug Connection
Loosen 1/2" (13mm)
wingnut. Insert wire
through hole and tighten
nut. Takes wire sizes up
to 8 gauge.
Insert banana plug into
the top of the wingnut.
Ensure the wingnuts are
tightened.
Loosen wingnut to expose
the top of the jumper strap.
A 1/4"(6mm) or 5/16"(8mm)
spade will fit on the
narrower section of the
post. Tighten the wingnut.
marked with ‘+’ plus signs, or one wire under the insulation may be
different from the other.) Use this wire coding, together with amp/receiver
and speaker colour-coding, to be sure you are connecting the same wire
of a given pair to a like-coded terminal at both ends of your connection.
Assure all wiring terminals are tightened firmly but be careful not to over
tighten and damage the connectors.
Bi-Wiring or Bi-Amping Options
PSB Synchrony speakers can be bi-wired (separate cables to the
separated woofers and midrange/tweeters from the same amplifier
(except on the Synchrony S Surround)) or bi-amped (separate
amplifiers). With single cable inputs, the jumper straps must be in place
and both sets of terminals tightened firmly. Before bi-wiring or bi-amping,
ALWAYS remove the metal jumper straps that connect the two sets of
binding posts on the speaker. Loosen ½” (13mm) wingnuts to remove the
jumper strap.With bi-amp hookup you must use either identical amplifiers
or amplifiers adjusted to have the same voltage gain. Consult your PSB
dealer or our Web site for further information.
14
Owner’s Manual