PYLE Audio PDWM2200 Microphone User Manual


  Open as PDF
of 5
 
BELT PACK TRANSMITTER
MIC IN
A. Overall system
1. Oscillation mode:
2. Carrier Frequency Range
3. Frequency Stability:
4. Max Deviation:
5. Dynamic Range:
6. S/N Ratio:
7. T. H. D:
8. Frequency Response
9. Operating Range:
B. Receiver
1. Sensitivity:
2. Image Rejection:
3. Stability:
4. Audio output:
5. Power supply:
C. Transmitter
1. Mike capsule:
2. Antenna:
3. RF Output:
4. Spurious:
5. Power Supply:
Quartz controlled
VHF160~270MHz
+/-0.005%
+/-56KHz with level limiting
>110dB
>100dB
<0.5dB
60Hz-18KHz
30M
6dB V at SIN >70dB
>60dB
>80dB
-12db/600ohm unbalanced
12V DC/500mA
Handheld: dynamic
Headset or lavalier MIC: condenser
Built-in housing(Handheld MIC)
external(Belt pack)
<10mW
<-40dBC
9V battery
SPECIFICATIONS
36
1. Open the battery cover to install a 9V battery as per correct
polarities.
2.
Plug the 3.5mm connector of headset mic to MIC in jack of
transmitter.
4. Before operation, please confirm that the frequency of
transmitter is same as the frequency of receiver.
5. When speak to the MIC, please keep 2-3cm distance between
mouth and mic head.
6. If the system will not be used for a long time, please take out
battery from transmitter to avoid damage by battery leakage.
Move power switch to ON position. Power LED indicator will
flash once and then go off. This indicates correct operation. If
power LED indicator lights red, this indicates the battery is
Iow. Please replace with new battery.
3.
9V BATTERYBATTERY COVER
POWER INDICATOR
POWER SWITCH
OPEN CLOSE
LAVALIER MIC HEADSET MIC
 previous