Filter
Top Products
HANDHELD MICROPHONE/DIAGRAM
SQUELCH
DC 12V
MIX
AF. OUT
BALANCED
ANT
Unscrew the battery cover at the end of the microphone, Install the provided
volt battery, taking care to fit it with the correct polarity connected,
Check the battery by switching the microphone ON, The red LED will come
on for one second and then go OFF, this indicates correct operation, If the
red LED stays ON or is dim, this indicates the battery is low and should be
changed, If the red LED does not come on at all, it indicates the battery
is dead, please change it right now,
9
BATTERY COVER
POWER SWITCH
BATTERY CONDITION
INDICATOR
UNSCREW BATTERY
COVER TO INSERT
BATTERY
MICROPHONE BATTERY.
MAINS POWER
ADAPTER
RADIO MIC
RECEIVER UNIT
SPEAKERS
MICROPHONE
AMPLIFIER
---3--- ---4---
INSTALLATION
To connect the wireless microphone to your amplifier system:
Refer to the installation diagram below.
Using the supplied jack-to-jack lead, connect from the AF OUT jack
socket to the MICROPHONE INPUT socket on your amplifier. Plug
the mains power adapter into a suitable mains socket, and plug the
lead connector into the DC 12V input socket.
With voltage selector switch for selecting a suitable
one according to different countries.
ANT
BALANCED
VOLTAGE
SELECTOR SWITCH