Filter
Top Products
Rear
Panel
(1) (4)ATTN Port:
install
ATTN A. ATTN B
(2)Mix
out
socket
(3)power:
11
OV/60Hz
(5)channel
B
Audio
out
(6)channel
AAudio
out
System
connection
flow
diagram
1
RECIEVER
1-----'8-----'
AMPLIFIER
L
KAROKEAMPLIFIER
Installation
ofreciever
• Keep the machine 1 m above the ground
• Keep the machine away 1 m against the wall.
• Pull the antenna up rightness fully
• Make the transmitter point to the antenna without barrier
• Keep the reciever away any digital equipment(such as
CD,VCD,PC. or other radio equipment)
Operation
Of
Hand
Held
Transmitter
1.
First open the battery housing
in
anti-clockwise direction.
2.Conserve the battery inside
on
the + - palarity of battery.
3.Fit the battery compartment back
in
clock wise direction.
4.Pull the sliting switch
of
the grips to the first stage, to
the out correct signal is sent out, the white LED indicator
is light. pull second stage so as to be ready for transm-
itting speech.
5.
Remove the sliding switch to the "off' side when it is not
used.lf it is not used
for
a long time. Please take out
the battery.
6.When filp the LED power switch
of
grip up. If one is light.
the volume
of
battery is normal,
if
the LED indicator is
light all the time. If the LED. indicator is neither bright,
nor light, the battery is used up recharge the battery.
Specifications
• Professional VHF 2 Channel Wireless System
• Dual Handheld Microphones Included
• Dual Telescoping Receiver Antennas
• Dual Volume Controls With Digital Readout
• Dual Charging System
• On/Off Broadcasting Switch
• 1/4" Individual line outputs
& Mixed 1/4" Outputs
• Carrier Frequency: 174MHz-216MHz
• Dynamic Range: 100dB
• Total Harmonic Distortion: 0.5%
• Frequency Response:
40Hz-18KHz
• Operation Range: 50-180 Meters
• Signal to Noise Ratio: 105dB
• Receiver Power Supply: AC
11
OV/240V
• Microphone Power Source: 8.4
Vo
lt Rechargeable
• Receiver Dimensions: 1.8" X 18.9" X 1.3"
• Microphone Dimensions: 9.6" X 0.7" X 0.5"