QSC Audio B SERIES DJ Equipment User Manual


  Open as PDF
of 4
 
3WLX0001 rev. B
9. WL2102-w and WL218-sw only: Reinstall the screws using a power drill-screwdriver at its lowest torque setting to lightly
secure the screws. Torque all of them to 60 in-lb or 7 N-m (Figure 5).
Quality review: Testing rigging hardware
All models: Rig the boxes together as they will be hung. Verify that all the parts are correctly oriented and tightly secured as
described in the procedure above (including the two front tubes and the rear angle plates). Vary the splay of each box to verify that
the knuckles are properly installed.
Regular inspection
All models: QSC recommends that the rigging hardware and attachments be inspected for damage and tightness before every lift.
Secure all loose components and replace any damaged parts before suspending the enclosure.
Loctite is a registered trademark, and QuickStix and 248 are trademarks, of the Henkel Corporation.
TORX is a trademark of Camcar LLC.
➜
Continued
Figure 5. Removing the 12 rear angle plate screws. Apply threadlock,
then reinstall and torque them.
Figure 4. WL2102-w and
WL218-sw only: Correct
orientation of the knuckle
for reinstallation.
WL3082
WL212-sw
Figure 3. Removing the rigging bar screws. Apply
threadlock, then reinstall and torque them. The WL3082
has three screws on each side, while the WL212-sw has
two.
 previous