RCF TX1000 Microphone User Manual


 
ENGLISH
23
EQUALIZER SWITCH
The DSP power makes it possible to equalise the audio signal; this function
has been implemented in a totally independent way from the feedback
suppression.
• SPEECH: The frequency response of the radiomicrophone is perfectly
flat. This selection is recommended for speech only.
• MUSIC: In this position, thanks to the DSP processing, middle, mid-bass
and bass tones are appropriately emphasised to make the microphone
sound warmer, mellow and “round”; the voice takes on fullness and
presence, so this option is particularly suitable to sing.
TRANSMITTER / HAND-HELD MICROPHONE TX 1000
TRANSMITTER / HAND-HELD MICROPHONE EQUIPPED WITH:
• Electret cardioid microphone.
• ON/OFF switch for the transmitter.
• MUTE switch.
• LED indicating the battery charge status.
USE:
• (!) Make sure the power switch is in the OFF position before inserting
the batteries.
• To access the battery compartment, remove the cover by pressing the
button and turning
the cover outwards at the same time.
• Insert a 9 V alkaline battery according to the polarity indications (+/-)
printed on the bottom and put the cover back on.
• Turn on the transmitter using the switch on the battery cover: the red
LED should stay lit only for a few seconds; if it stays lit longer, the battery
is very low and should be replaced.
• Make sure the MUTE switch (on the upper part, near the mic. capsule) is
set to MIC.
• Check the transmitter is working correctly: one of the two green LEDs
A/B on the respective receiver should be lit.