Filter
Top Products
53
Network Management
On this page Network Information for the Executive Elite is organized for easy
access and management.
The DHCP section allows enabling or disabling DHCP on the Executive Elite
base DSP. If DHCP is enabled, the Executive Elite base DSP will request an IP
address from your DHCP server.
If DHCP is disabled, the IP section allows setting a static IP Address and other
network information. While DHCP is enabled, these fields cannot be accessed
and changed; enabling DHCP will delete any data previously entered into the
static address fields.
It is important that this information be filled out correctly before saving
changes, as otherwise the Executive Elite system will not be accessible through
the IP connection.
NOTE: If the network settings are configured incorrectly it can cause the
Elite to become disconnected from the network, making access to
the Web UI over the LAN impossible, even to fix the network
configuration settings. However, the Web UI can still be accessed
from the USB port on the front panel of the Elite. Connect your
computer with the Executive Elite base’s front panel USB port
using a micro USB cable. If required, the operating system will
install driver software on your computer. After that is complete go
into the menu on the Front Panel LCD, where a popup should have