79
To use the Elite Wearable Microphone:
1. Remove the microphone from the Charger Base.
2. Attach the microphone to clothing or to a lanyard, positioning the
microphone just above the sternum or breastbone, within 6 - 12 inches (15
– 30cm) from the mouth. Make sure that the microphone is attached
securely. The Elite wearable microphone utilizes an omni-directional
microphone element, it is therefore not important that the microphone
points up towards the mouth.
3. After positioning the microphone, based on the mute behavior defined for
that microphone un-mute and mute it by pressing and releasing the Mute
button (confirm by a flashing green LED or red LED, respectively). If the
volume is too low, mute the microphone, relocate it closer to the mouth, and
unmute it again.
4. To turn the microphones off, return the microphone unit to the Charger
Base or press and hold the Mute button for about 10 seconds until the LED
turns solid red, then release the button. The microphone can also be
turned off from the local web UI or the room control interface. Note that, in
push to talk mode the microphone cannot be shut down using the mute
button.
If the microphones are moved out of range of the Remote Antenna (depending
on the RF power setting this can be 300 feet, 90 meters, or more from the
Remote Antenna), the connection will be dropped, the LED flashes red, yellow,
green, yellow, and the microphone will mute.
After 15 seconds the microphone will beep, and will continue beeping every 30
seconds to remind the user to return the microphone to the conference room. If
the microphone is moved back into range of the Remote Antenna within 15
minutes the connection will automatically be re-established to its original state,
and the beeping will cease. If not, the microphone will turn off.