Filter
Top Products
Español Italiano Français Deutsch EnglishPortuguêsNederlands
9
Panel Descriptions
You can switch to either of two delay
types or the LOOPER function by
positioning this knob.
When the knob is at WARM or CLEAR,
this functions as a delay, and you can
adjust the volume level of the delay by
adjusting the knob’s position.
The indicator lights up when delay is on and goes out when it’s
off. You can also switch this on and off using an optional
footswitch pedal.
When the knob is positioned at LOOPER, you can use it to adjust
the volume level of playback using the LOOPER function.
This indicator lights up when the LOOPER function is on. The
indicator flashes when a footswitch pedal is used to switch off
(mute) LOOPER.
* The scale indications for WARM, CLEAR, and LOOPER are just a general
guide. Be sure to check the actual sound as you adjust the effect.
* When the knob is positioned at LOOPER, no delay effect is applied. To
use the LOOPER and delay simultaneously, refer to
“Using the LOOPER
Function and Delay at the Same Time” (p. 18).
TAP Switch
When the knob is positioned at WARM or CLEAR, you can
use this to adjust the delay time.
When the knob is positioned at LOOPER, this switch
controls recording, playback, and overdubbing.
You can switch between use of two types of
reverb by changing the position of the knob.
You can adjust the intensity of the effect by
varying the knob position.
The indicator lights up when reverb is on and
goes out when the effect is off. You can also
switch reverb on and off using an optional
footswitch pedal.
DELAY/LOOPER Knob
Knob Position Function Description
WARM
Delay
This is a feedback delay with
a warm analog-delay feel.
Turn the knob clockwise to
increase the effect sound.
CLEAR
This is a delay with one to
two repetitions.
Turn the knob clockwise to
increase the effect sound.
LOOPER Looper
This enables the loop-play
mode.
You can vary the volume
level for playback by
adjusting the position of the
knob. For more information,
refer to
“Using the LOOPER”
(p. 17).
Knob
Position
Function Operation
WARM,
CLEAR
Adjusts the
delay time
Delay time of 90 ms or more
Pressing the switch twice sets
a
delay time equal to the
interval between presses. You
can set a time of up to 2,000 ms
when the knob is at WARM or
up to 1,000 ms when the knob
is at CLEAR.
Delay time of 90 to 30 ms
Holding down the TAP switch
for one second or longer
changes the delay time in a
stepwise fashion from 30 to 90
ms, according to the number of
seconds you hold the switch
depressed (four stages: 30 ms,
50 ms, 70 ms, and 90 ms).
LOOPER
Starts and
stops Looper
recording
and playback
Refer to “Using the LOOPER
Function and Delay at the Same
Time” (p. 18).
REVERB Knob
Knob Position Description
SPRING
This is modeled on spring reverb.
It produces the distinctive
reverberations of a spring. Turning the
knob clockwise makes the effect
progressively more intense.
PLATE
This is a plate reverb.
This reverb features high-end sustain.
Turning the knob clockwise makes the
effect progressively more intense.
cube-80x.book 9 ページ ２００８年１２月１２日 金曜日 午後６時７分