Filter
Top Products
9
Button Names and Functions
11. Foot Switch
By connecting a foot switch such as the FS-5L (sold
separately), you can control a variety of such as with your
feet.
TIP:A/B and RING:MANUAL Jack
You can use a foot switch to switch between memory A and
memory B or switch the Manual function on and off.
fig. 3 (explanatory figure)
TIP: Switches between memory A and memory B.
RING: This switches the Manual function on and off. When
switched off, the settings of the memory just selected
are used.
(When using the FS-5L)
When using the FS-5L to switch the Manual
function on and off, set the polarity switch as
shown in the diagram above. With this setting,
the indicator of the FS-5L will light when the
Manual function is on.
When using a stereo connection cord, be sure to use two
foot switches. Use with one plug empty may result in
unstable operation.
When a foot switch is connected to this jack, the
MANUAL, MEMORY A, and MEMORY B buttons
do not function.
When using the amp with a single foot switch, use a
monaural cord to connect the foot switch. In this case,
this switches between memory A and memory B. Also
MANUAL button does not function.
CHORUS jack
This lets you switch the chorus effect on and off.
(When using the FS-5L)
Set the polarity switch as shown in the diagram
below. With this setting, the indicator of the FS-
5L will light when the Chorus effect is on.
fig. 4 (explanatory figure)
When the D-chorus INTENSITY knob setting is made
or stored while at “OFF,” the foot switch cannot be
used to switch chorus on or off.
If the D-chorus INTENSITY knob has been used to
turn on the Chorus effect, using the foot switch to turn
off the Chorus effect will cause the D-CHORUS
indicator to blink.
A/B
TIP :
MANUALRING:
WHITE
RED
Manual function ON/OFF
Switch between Memory A
and MemoryB
Polarity
switch
NOTE
NOTE
NOTE
CHORUS
Polarity
switch
NOTE
NOTE