Filter
Top Products
®ÂØÒňÎ
®
JV-1010
64-Voice Synthesizer
Module
TurboStart
TBS98 © 1999 Roland Corporation U.S., 5100 S. Eastern Ave., Los Angeles CA 90040 Faxback # 20094 Page 2
Auditioning Patches (Phrase Preview)
The Phrase Preview function allows you to audition
sounds at the touch of a button. A short sample of the
selected patch is played in a style associated with
that sound. Use the following procedure to try the
Phrase Preview function:
1. Press the VALUE knob to select the Patch
mode.
2. Turn the CATEGORY/BANK knob to select
Session.
3. Turn the VALUE knob to select 023.
4. Hold down the VOLUME knob to hear the
selected patch.
Using the JV-1010 as a GM Module
The JV-1010 features a GM (General MIDI) mode
that provides a convenient way to play back or create
General MIDI-compatible files. Use the following
procedure to place the JV-1010 into GM mode:
1. Press the VALUE knob repeatedly to select GM.
Configuring the JV-1010 with
SoundDiver
A copy of Emagic’s SoundDiver is included for patch
editing on the JV-1010. This software allows you to
quickly and easily edit the parameters of the JV-1010
from your Mac or PC.
Before you can do this, it is necessary to configure the
JV-1010 for use with your computer. First, you will
need to connect the proper cable—for PC use RSC-
15AT, for Mac use RSC-15APL—to the serial port on
your computer. Or, if you already have a MIDI
interface, connect the MIDI ports on the JV-1010 to
your interface.
Make sure the power for the JV-1010, the computer,
and any additional devices is turned off, and use the
following procedures to configure the JV-1010 for use
with SoundDiver.
For PC:
1. Connect a RSC-15AT serial cable from the serial
port of the JV-1010 to the computer’s serial port
(RS-232C).
2. Set the COMPUTER switch on the rear panel to
PC-2.
3. Turn the power for all devices on.
For Mac:
1. Connect a RSC-15APL serial cable from the
serial port of the JV-1010 to the computer’s
serial port.
2. Set the COMPUTER switch on the rear panel to
Mac.
3. Turn the power for all devices on.
Using MIDI:
1. Set the COMPUTER switch on the rear panel to
MIDI.
2. Connect a MIDI cable from the JV-1010’s MIDI
OUT to the MIDI IN of the MIDI interface.
3. Connect a MIDI cable from the JV-1010’s MIDI
IN to the MIDI OUT of the MIDI interface.
4. Turn the power for all devices on.