Filter
Top Products
7
Mounting The Drum Trigger
fig.RT-10K-toritsuke
1.
Attach the included hoop guards (2) to the inner and outer sides of the kick drum hoop.
• Attach the hoop guards at one of the positions indicated in the figure.
We suggest these positions in order to keep the trigger as far away from the snare drum or
tom toms as possible.
• Make sure the hoop guards to not touch any of the tension bolts.
2.
Use a drum key to loosen the RT-10K’s sensor bolt.
3.
Mount the RT-10K on the hoop guards (Step 1), then firmly tighten the mounting screw to secure
the trigger to the hoop.
Firmly secure the mounting screw to prevent the drum trigger from falling off.
1.
Use a drum key to loosen the RT-10S/RT-10T’s sensor bolt.
2.
Mount the RT-10S/RT-10T to the drum hoop, then turn the mounting screw to secure it in place.
Be sure it does not be touch any tension bolts and position it opposite yourself so that it doesn't
hinder performance, and so you don't hit it accidently.
* Do not insert fingers inside the trigger case and do not touch the board inside. When moving the drum with
the trigger mounted, only hold the drum itself. Never place excess stress on the trigger itself.
RT-10S Snare Trigger/ RT-10T Tom Trigger
Hoop Guard
RT-10K
RT-10KST_e.fm 7 ページ ２００６年３月３０日 木曜日 午後１時５５分