Filter
Top Products
10
Create a Wind Sound
4
STEP
Use Cuto to Control the Character of the Wind
As you turn the [CUTOFF] knob
toward the left, the sound will
become more mu ed. When the
knob is turned all the way toward
the left, the sound will be nearly
inaudible. This is because most of the
frequency range is not being allowed
to pass.
Let’s try playing a wind sound that was created using noise. Noise allows you to produce this type of sound.
We’ll try controlling the character of the wind while listening to it.
1. Turn the FILTER [CUTOFF] knob all the way to
the left.
2. Call up the “PRESET A-8” patch.
Press the [PRESET
PATCH] button
Press the [8] button
Press the [BANK] button and
then press the [1] (A) button
3. Press the [KEY HOLD] button so it’s blinking.
4. Press and hold any key. The wind will start
blowing.
The sound of trickling water will also begin.
5. While holding down the key to make the wind
continue blowing, turn the FILTER [CUTOFF]
knob toward the right, and move it between
the 10 o’clock and 1 o’clock positions.
This lets you control the character of the wind.
Level
Frequency
Overtones
being cut
A NOTE OF
ADVICE
ADVICE
ADVICE