Filter
Top Products
10
About the SRX-12 dedicated piano mode (for Fantom-X6/X7/X8 users)
[F6 (Phaser)]
Switches the phaser on/off.
When you switch the phaser on, the following functions will be
assigned to realtime control knobs 1–4.
[F7 (EQ)]
Switches the equalizer on/off.
When you switch the equalizer on, the following functions will be
assigned to realtime control knobs 1–4.
[F8 (Speaker SIM)]
Switches the speaker simulator on/off.
When you switch the speaker simulator on, the following functions
will be assigned to realtime control knobs 1–4.
Specifications of each speaker type
The “Speakers” column indicates the diameter of each speaker unit
(in inches) and the number of units.
Saving your settings
• The current settings will be preserved when you switch from
the Classic EP screen to another screen.
* The effect on/off status is preserved, but the knob settings of each effect
are not preserved.
• A sound you edit using the manual controls can be saved by
pressing [WRITE] and saving it as a Fantom-X6/X7/X8 user
patch. For details on how to save a sound, refer to the Fantom-
X6/X7/X8 owner’s manual.
Knob
Function Range Explanation
1
Manual 0–127 Adjusts the pitch at which
the phaser is applied. As
you turn the knob toward
the right, the phaser will be
applied to a higher pitch
range.
2 Rate 0.05–10.00
(Hz)
Adjusts the modulation
speed of the phaser. Turn
the knob toward the right
for faster modulation.
3 Depth 0–127 Adjusts the modulation
depth of the phaser. Turn
the knob toward the right
for deeper modulation.
4 Reso-
nance
0–127 Adjusts the amount of reso-
nance. Turn the knob to-
ward the right to increase
the resonance, producing a
more strongly distinctive
modulation.
Knob Function Range Explanation
1 Low Gain -15– +15 (dB) Adjusts the amount
of boost/cut for the
low-frequency range.
2 Mid Gain -15– +15 (dB) Adjusts the amount
of boost/cut for the
mid-frequency range.
3 High
Gain
-15– +15 (dB) Adjusts the amount
of boost/cut for the
high-frequency
range.
4 Level 0–127 Adjusts the output
volume of the equal-
izer.
* If you turn the knob
all the way toward
the left, there will be
no sound.
Knob
Function Range Explanation
1
Speaker (see below) Selects the type of speaker.
2 Mic Level 0–127 Adjusts the volume of the
mic that picks up the
sound from the speaker.
3 Dir Level 0–127 Adjusts the volume of the
direct sound.
4 Level 0–127 Adjusts the output vol-
ume.
Type
Cabinet Speakers Mic
SMALL 1
Small open back 10" x 1 Dynamic
SMALL 2 Small open back 10" x 1 Dynamic
MIDDLE Open back 12" x 1 Dynamic
JC-120 Open back 12" x 2 Dynamic
BUILT-IN 1 Open back 12" x 2 Dynamic
BUILT-IN 2 Open back 12" x 2 Condenser
BUILT-IN 3 Open back 12" x 2 Condenser
BUILT-IN 4 Open back 12" x 2 Condenser
BUILT-IN 5 Open back 12" x 2 Condenser
BG STACK 1 Sealed 12" x 2 Condenser
BG STACK 2 Large sealed 12" x 2 Condenser
MS STACK 1 Large sealed 12" x 4 Condenser
MS STACK 2 Large sealed 12" x 4 Condenser
METAL
STACK
Large double stack 12" x 4 Condenser
2-STACK Large double stack 12" x 4 Condenser
3-STACK Large triple stack 12" x 4 Condenser
SRX-12_je.book 10 ページ ２００６年４月１１日 火曜日 午前１１時６分