Filter
Top Products
13
USING THE UNIT SAFELY
1.
Loosen the stand’s anchor bolts and remove
the foot plate.
fig.KD-Assy06
2.
Set the kick pedal so that the entire bottom
surface is attached to the floor.
3.
In most cases, the stand becomes somewhat
floated. Tighten the anchor bolts securely there
to fix the stand and foot plate.
fig.KD-Assy07.e
• Install the kick pedal securely.
• Take care not to pinch your fingers.
• The tips of the anchor bolts are sharp. Handle with care.
• When moving the setup, be sure to remove the screws
and fold the stand. Transporting the KD-8 while it
remains open may subject the stand to excessive strain
and result in damage to the stand.
Adjusting the Anchor Bolts
When using the kick pedal on a carpet or similar surface,
adjust the anchor bolts so their tips protrude from the plate
and secure the pedal in place; this will make it easier to use the
kick pedal.
However, when used on flooring, the anchor bolts may
damage the floor. Adjust the anchor bolts correctly.
fig.KD-Anchor.e
The tips of the anchor bolts are sharp. Handle with care.
When Using a Twin Pedal
fig.KD-Pedal1
Position the two beaters
equally apart from the center
of the pad as shown in the
figure at left. If one of the
beater is further away from the
center than the other, the
sound from the further beater
will be lower in volume, or
will not sound as desired.
fig.KD-Pedal2
Using a twin pedal will result
in lower sensitivity as
compared to when a single
pedal is used. Raise the
sensitivity on the sound
module.
KD-8
Dimensions: 272 (W) x 260 (D) x 405 (H) mm
10-3/4 (W) x 10-1/4 (D) x 16 (H) inches
Weight: 2.9 kg
6 lbs 7 oz
Accessory: Screws
* Continuous playing may cause dis-coloration of the pad, but
this will not affect the Pad's function.
This hight will vary depending
on your kick pedal.
Specifications
When Using on the Carpet When using on the Floor
Adjusting the Anchor Bolts
TD-3KW_e 13 ページ ２００６年１０月２５日 水曜日 午後５時３分